Daikin F-Series Service Manual page 128

SiBE12-712C
Outdoor Unit
Indoor Unit
1. Air filter
2. Titanium Apatite Photocatalytic
Air-Purifying Filter :
• These filters are attached to the inside of
the air filters.
3. Air inlet
4. Front panel
5. Supporting plate:
• The supporting plate is used to support the
front panel during maintenance.
6. Panel tab
7. Flap (horizontal blade)
8. Air outlet
9. Louvers (vert i cal blades):
• The louvers are inside of the air outlet.
10. Outlet vent panel
11. Display
12. Indoor Unit ON/OFF switch:
• Push this switch once to start operation.
Push once again to stop it.
Outdoor Unit
19. Air inlet: (Back and side)
20. Air outlet
21. Refrigerant piping and inter-unit cable
Appearance of the outdoor unit may differ from some models.
Operation Manual
• The operation mode refers to the following
table.
Mode
F(C)TXG AUTO
• This switch is useful when the remote controller
is missing.
13. Room temperature sensor:
• It senses the air temperature around the unit.
14. Operation lamp (green)
15. TIMER lamp (yellow)
16. INTELLIGENT EYE lamp (green)
17. INTELLIGENT EYE sensor:
• It detects the movements of people and auto-
matically switches between normal operation
and energy saving operation.
18. Signal receiver:
• It receives signals from the remote controller.
• When the unit receives a signal, you will hear a
short beep.
• Operation start .............beep-beep
• Settings changed..........beep
• Operation stop ..............beeeeep
22. Drain hose
23. Earth terminal:
• It is inside of this cover.
Instruction
Tempera- Airflow
ture setting rate
25°C AUTO
117