Ordering - GE T60 Instruction Manual

2 PRODUCT DESCRIPTION
Table 2–2: OTHER DEVICE FUNCTIONS
FUNCTION
2
Breaker Arcing Current I
Contact Inputs (up to 96)
Contact Outputs (up to 64)
Control Pushbuttons
Data Logger
Digital Counters (8)
Digital Elements (48)
Direct Inputs/Outputs (32)
DNP 3.0 or IEC 60870-5-104 Protocol
Ethernet Global Data Protocol (optional)
Event Recorder
FlexElements™ (16)
The T60 is available as a 19-inch rack horizontal mount unit or a reduced size (¾) vertical mount unit, and consists of the
following modules: CPU, faceplate, power supply, CPU, CT/VT, digital input/outputs, and inter-relay communications. Each
of these modules can be supplied in a number of configurations specified at the time of ordering. The information required
to completely specify the relay is provided in the following tables (see Chapter 3 for full details of relay modules).
Order codes are subject to change without notice. Refer to the GE Multilin ordering page at
trial.com/multilin/order.htm
NOTE
GE Multilin
Courtesy of NationalSwitchgear.com
FUNCTION
t FlexLogic™ Equations
IEC 61850 Communications (optional)
Metering: Current, Voltage, Power,
Modbus Communications
Modbus User Map
Non-Volatile Latches
Non-Volatile Selector Switch
Oscillography
Setting Groups (6)
Time Synchronization over SNTP
Transducer Inputs/Outputs
for the latest details concerning T60 ordering options.
T60 Transformer Management Relay
Power Factor, Energy,
Frequency, Harmonics, THD
2.1 INTRODUCTION
FUNCTION
Transformer Aging Factor
Transformer Hottest-Spot Temperature
Transformer Loss-of-Life
User Definable Displays
User Programmable Fault Reports
User Programmable LEDs
User Programmable Pushbuttons
User Programmable Self-Tests
Virtual Inputs (64)
Virtual Outputs (96)
VT Fuse Failure

2.1.2 ORDERING

http://www.GEindus-
2
2-3