Rs232 Faceplate Port; Cpu Communication Ports - GE T60 Instruction Manual

3 HARDWARE
A 9-pin RS232C serial port is located on the relay's faceplate for programming with a portable (personal) computer. All that
is required to use this interface is a personal computer running the EnerVista UR Setup software provided with the relay.
Cabling for the RS232 port is shown in the following figure for both 9 pin and 25 pin connectors.
The baud rate for this port is fixed at 19200 bps.
NOTE
a) OPTIONS
In addition to the RS232 port on the faceplate, the relay provides the user with two additional communication port(s)
depending on the CPU module installed.
The CPU modules do not require a surge ground connection.
NOTE
CPU TYPE COM1
9E RS485
9G 10Base-F and 10Base-T
9H Redundant 10Base-F
9J 100Base-FX
9K Redundant 100Base-FX
9L 100Base-FX
9M Redundant 100Base-FX
9N 10/100Base-T
9P 100Base-FX
9R Redundant 100Base-FX
GE Multilin
Courtesy of NationalSwitchgear.com
Figure 3–20: RS232 FACEPLATE PORT CONNECTION
COM2
RS485
RS485
RS485
RS485
RS485
RS485
RS485
RS485
RS485
RS485
T60 Transformer Management Relay
3.2 WIRING

3.2.7 RS232 FACEPLATE PORT

3.2.8 CPU COMMUNICATION PORTS

3
3-19