Attaching The Ap150 Antennas; Mounting The Access Point - Meru Networks ap150 Installation Manual

Installing the Access Point

Attaching the AP150 Antennas

The AP150 is provided with external antenna ports. Make sure that all external antennas and their
associated wiring are located entirely indoors. The external antennas are not suitable for outside use.
If the AP150 does not have external antennas, attach the antennas to the connectors on the AP150 (see
Figure
ring should be finger-tight.
Caution!
before moving the antenna. Retighten the ring afterward. Otherwise, you might damage the internal
cabling in the AP.

Mounting the Access Point

You can mount an AP150 in the following ways:
Horizontally, as described in the
Vertically, as described in the
Below a hanging ceiling, as described in the
Above a tiled hanging ceiling, as described in the
section.
Horizontal Mounting
To horizontally mount an AP150:
1.
2.
30 Meru Access Point Installation Guide
17). Rotate the knurled ring at the base of the antenna clockwise to attach the antenna. The
When changing the orientation of the antennas, be sure to slightly loosen the knurled ring
Place the AP150 flat on the horizontal surface.
For each antenna, loosen the knurled ring at the base of the antenna (see
antenna straight up, then retighten the ring.
"Horizontal Mounting"
"Vertical Mounting" section.
"Mounting Below a Suspended Ceiling"
"Mounting Above a Suspended Ceiling"
section.
Figure 17), point the
section.