Ingress Rate Limit Configuration - Zte ZXV10 H11X User Manual

ZXV10 H11X (V1.0)Home Gateway User's Manual
Outer face
Out-interface of the data flow
DSCP
DSCP value of data flow, in the range of 0~69
Set Mark
Whether to set mark for the data flow
Priority
Priority of the data flow

Ingress Rate Limit Configuration

Click the Ingress Rate Limit link on the left part of the page to
enter the Ingress Rate Limit configuration page. Ingress rate limit
can limit the incoming data flow rates of all the interfaces. You can
enable ingress rate limit at an interface, configure the incoming data
flow protocol, source address/port and destination address/port, and
control the rate of this data flow.
Interface
Network interface, on which ingress rate limit is enabled
70 Confidential and Proprietary Information of ZTE CORPORATION