Wireless Network Sub-Interface Configuration - Zte ZXV10 H11X User Manual

Zone
The used country or region
Beacon Interval
Beacon interval (ms)
Tx Rate
Configuring the data transmission power of the device;
Select a lower data transmission rate to achieve the
maximum value of the wireless communication range. The
default value is Auto.
Tx Power
Transmitting power grade
Enable WLANx
Enable or disable a WLAN sub-interface (up to 4 WLAN
sub-interface can be enabled at the same time).
ESSID
Wireless network service area ID, consisting of up to 32
characters with case sensitivity and used to control
wireless network access; This value must match SSID of
any access point for communication. Otherwise, the
system cannot be accessed (the system supports enabling
of four wireless network sub-interfaces at most).
Wireless Network Sub-interface
Configuration
Click the LAN Configuration link on the left side of the page to
enter the LAN Configuration page. Click the wireless interface
name link to enter the related configuration page of wireless network
sub-interface.
1. Basic information display of wireless network sub-interface
After entering the configuration page of wireless network
sub-interface, click the Basic link at the upper part of the
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 4 - Basic Configuration
41