Zte ZXV10 H11X User Manual page 22

ZXV10 H11X (V1.0)Home Gateway User's Manual
straight-through Ethernet cable. You can also connect the H110 or
the PC through the WLAN radio frequency signal line or USB cable.
Connect the local network via an Ethernet cable.
The four LAN interfaces of the H110 can auto-negotiate the
connection speed of the 10 Mbps/100 Mbps Ethernet and the
half-duplex/full-duplex transmission mode.
Use a cross-over or straight-through Ethernet cable to connect
any LAN interface of the H110 to your PC.
You can also connect an LAN interface of the H110 to the
Ethernet hub or the Ethernet switch, and then connect your PC
or another network device to the hub or the Ethernet switch.
Connect the local network through WLAN.
Install a wireless network adapter on your PC and then connect
the local network through the IEEE 802.11g/b-based WLAN. Try
to place the H110 in the center of the wireless center to achieve
the optimal coverage. Make sure that you have placed the H110
in the idealist location in the whole office or house.
When connecting the local network via WLAN, make sure that
the WLAN button on the rear panel of the H110 is switched on.
Connect your local network through USB cables.
Connect your PC and the USB Slave interface of the H110
through the USB connection line and install the driver of the USB
network adapter on the PC. In this way, you can access the local
network through USB just as the way you use a wired Ethernet.
22 Confidential and Proprietary Information of ZTE CORPORATION
Be sure not to insert the telephone line
Warning:
into any RJ-45 network interface. Otherwise, the
H110 will be damaged. Use Ethernet cables with
RJ-45 connectors
standard.
in compliance with the CE