Removing The Cover Of The Model 225 - IBM totalstorage 200 Hardware Installation Manual

Removing the Model 225 cover:
Figure 6. Removing the cover of the Model 225
To remove the appliance top cover:
1. Review the information in "Preparing to install a memory module" on page 14.
2. Switch OFF the appliance and all attached devices and disconnect all external
3. Release the left and right side latches and pull the appliance out of the rack
4. Move the cover-release lever down while sliding the top cover toward the rear of
16
™
IBM TotalStorage Network Attached Storage 200 Installation Guide
cables and power cords.
enclosure until both slide rails lock.
Note: When the appliance is in the locked position, you can reach the cables
on the back of the appliance.
the appliance about 25 mm (1 in.). Lift the cover off the appliance and set the
cover aside.
Attention: For proper cooling and airflow, replace the cover before switching
on the appliance. Operating the appliance for extended periods of time (over 30
minutes) with the cover removed might damage appliance components.
Top cover
Right-side
latch
Cover release lever
Left-side latch