Model 225 Front View - IBM totalstorage 200 Hardware Installation Manual

Figure 20. Model 225 front view
Reset Button Press this button to reset the appliance and run the POST.
Operator Information panel
Hard Drive Status LED
Hard Drive Activity LED
36
™
IBM TotalStorage Network Attached Storage 200 Installation Guide
1
Cover-release latch
2
Serial Number
3
Hard Drive Status LED
4
Hard Drive Activity LED
5
Reset Button
6
Power Control Button
7
Power Control Button Shield (if installed)
8
Operator Information panel
Attention:
Pressing this button when the appliance is booting up or operating
may make the appliance non-operational or corrupt the drives.
The LEDs on this panel give status information for your appliance.
See "Operator information panel" on page 39 for more information.
Each of the hot-swap drives has a Hard Drive Status LED. When
this amber LED is on continuously, the drive has failed. When the
LED flashes slowly (one flash per second), the drive is being
rebuilt. When the LED flashes rapidly (three flashes per second),
the controller is identifying the drive.
Each of the hot-swap drives has a Hard Drive Activity LED. When
this green LED is flashing, the controller is accessing the drive.
Press this button only when the appliance is hung.