Adding Or Removing Internal Hardware Components; Removing The Cover (Model 200); Removing The Cover Of The Model 200 - IBM totalstorage 200 Hardware Installation Manual

POST Complete LED
SCSI Hard Drive In-use LED

Adding or removing internal hardware components

This section describes how to add or remove internal hardware components.

Removing the cover (Model 200)

The following sections describe how to remove the cover, the door (for the Model
200), and the bezel.
Figure 24. Removing the cover of the Model 200
To remove the left-side cover of the Model 200:
1. Review the information in "Before you begin" on page 27.
2. If you are planning to install or remove any part other than a hot-swap hard disk
3. Slide the cover-release lever on the front of the appliance to release the cover;
40
™
IBM TotalStorage Network Attached Storage 200 Installation Guide
This green LED is on when the appliance completes the POST without any
errors.
This green LED is on when there is activity on a hard drive.
Left-side cover
drive or hot-swap power supply, switch off the appliance and all attached
devices and disconnect all external cables and power cords.
then, slide the cover toward the rear of the appliance about 25 mm (1 in.). Move
the top edge of the cover out from the appliance; then, lift the cover off the
appliance. Set the cover aside.
Attention: For proper cooling and airflow, replace the cover before switching
on the appliance. Operating the appliance for extended periods of time (over 30
minutes) with the cover removed might damage appliance components.
Cover
release
lever