Connecting A Serveraid-4H Controller External Channel Connector - IBM totalstorage 200 Hardware Installation Manual

To attach SCSI devices to an external channel connector on the ServeRAID-4H
controller:
1. Connect one end of a 68-pin very high density connector interface (VHDCI)
Figure 39. Connecting a ServeRAID-4H controller external channel connector
2. Connect the other end of the SCSI cable to the external SCSI device.
3. Continue with "Updating BIOS and firmware code".
Updating BIOS and firmware code
Before configuring the ServeRAID controller, you must have the latest BIOS and
firmware code installed on your appliance.
1. Attach a keyboard and monitor to the appliance.
2. Start a browser.
3. Go to www.ibm.com/storage/support/nas
4. Select BIOS and firmware code for the ServeRAID controller.
5. Boot the diskettes as directed and follow the instructions on the screen.
6. Remove the diskette and reboot the appliance.
Configuring the ServeRAID Controller
Follow these instructions to configure a ServeRAID Controller:
56
™
IBM TotalStorage Network Attached Storage 200 Installation Guide
SCSI cable to an external channel connector on the ServeRAID controller.
Note: Refer to "ServeRAID-4H controller connector locations" on page 52 for
the channel connector locations.
1. Attach a keyboard and a monitor to the appliance; then, swich on the
appliance.
Note: A ServeRAID BIOS message appears. If the BIOS detects a mismatch
in the configuration, it shows a status of Fail and prompts you to press
a function key to continue. Press F10 to continue without changing the
configuration.
2. When prompted to start the Mini-Configuration Program, press Ctrl-I.