Input/Output Ports; Input/Output Connectors (Ports) And Expansion Slots - IBM totalstorage 200 Hardware Installation Manual

Management
Figure 49. Input/output connectors (ports) and expansion slots
Note: The Management connector is dedicated for use by the Advanced System

Input/output ports

This section provides information about the input/output (I/O) ports on your
appliance. These ports include the following:
v One integrated Ethernet port (used for configuration and service only)
v One Advanced System Management port
v ServeRAID ports
v Additional Ethernet PCI port
Ethernet port
Your appliance comes with an integrated 10/100 Ethernet controller. This controller
provides an interface for connecting to 10-Mbps or 100-Mbps networks and
provides full-duplex (FDX) capability, which enables simultaneous transmission and
reception of data on the Ethernet local area network (LAN).
To access the Ethernet port, connect a Category 3, 4 or 5 unshielded twisted-pair
(UTP) cable to the RJ-45 connector on the rear of your appliance.
Notes:
1. The 100BASE-TX Fast Ethernet standard requires that the cabling in the
2. If you plan to use the IBM Advanced Appliance Configuration Utility to configure
Serial A
Mouse
Keyboard
Ethernet
Video
Advanced System
Management
Interconnect knockout
Management processor.
network be Category 5 or higher.
and manage your appliance, be sure to connect the built-in Ethernet connector
to the same physical network as your systems management console.
Chapter 3. Adding and replacing components
69