Replacing The Cover, Door, And Bezel; Replace The Model 200 Cover - IBM totalstorage 200 Hardware Installation Manual

Replacing the cover, door, and bezel

Replacing the cover
Model 200:
Figure 45. Replace the Model 200 cover
To replace the appliance left-side cover:
1. Align the cover with the left side of the appliance, about 25 mm (1 in.) from the
2. Insert the tabs at the top of the cover into the slots at the top of the appliance.
3. Hold the cover against the appliance and slide the cover toward the front of the
Slots
Left-side cover
front of the appliance; place the bottom of the cover on the bottom rail of the
chassis.
appliance until the cover clicks into place.
Chapter 3. Adding and replacing components
65