Replacing The Model 200 Cover - IBM totalstorage 200 Hardware Installation Manual

Replacing the cover

Replacing the Model 200 cover:

Left-side cover
Figure 8. Replacing the Model 200 cover
To replace the appliance left-side cover:
1. Align the cover with the left side of the appliance, about 25 mm (1 in.) from the
front of the appliance; place the bottom of the cover on the bottom rail of the
chassis.
2. Insert the tabs at the top of the cover into the slots at the top of the appliance.
3. Hold the cover against the appliance and slide the cover toward the front of the
appliance until the cover clicks into place.
4. Switch on the appliance.
5. The system displays a message indicating that the memory configuration has
changed. Start the Configuration/Setup Utility program and select Save
Settings.
6. Restart the appliance.
Slots
Chapter 2. Installation procedures
19