Fully Utilizing Convenient Features; Continuing Printing Even If Media Contact; The Head Gap Sensor - Roland VersaUV LEF-20 Master Manual

Fully Utilizing Convenient Features

Continuing Printing even If Media
Contact the Head Gap Sensor
This setting allows the height to be readjusted
automatically to continue printing even when
the media moves out of position or lifts up
and comes into contact with the head gap
sensor during printing. (*)
This function is effective for printing on media
that cannot be redone.
Procedure
1.
Press [MENU] .
2.
Press [ ] to display the figure on the below .
MENU
SUB MENU
3.
Press [ ] .
4.
Press [ ] several times until the screen
shown on the below appears .
SUB MENU
CLEARANCE MODE
5.
Press [ ] .
CLEARANCE MODE
CANCEL RE-ADJ.
6.
Press [ ] [ ] to select "RE-ADJ . "
CLEARANCE MODE Explanation
RE-ADJ
CANCEL
(Default settings)
7.
Press [ENTER] .
20 Chapter 1 Fully Utilizing the Machine
The height is readjusted and
printing continues even when
the media comes into contact
with the head gap sensor dur-
ing printing.
Printing and setup will be can-
celed when the media comes
into contact with the head gap
sensor during printing. (**)
8.
Press [MENU] [ ] in this order to return to
the original screen .
Description
When the height is readjusted automatically,
and printing continues, the height setting is
changed, and therefore the print quality may
be changed. Hence, proper printing requires
properly securing the media before printing
to keep it from moving out of position or
lifting up.
" "1. How to Secure the Media (Media Setup)"
(First Step Guide)
" "2. Setting Height of Media Automatically"
(First Step Guide)
" "Setting Height of Media Manually" (p.
8)
At the time when the height is readjusted
automatically, the head gap sensor comes
into contact with the media.
Even if "RE-ADJ" is selected, printing and setup
will be canceled in the following cases.
• In automatic readjustment, the flat table
descends more than 10 mm (0.4 inches).
• In automatic readjustment, even if the flat
table has moved to the bottom, the media
comes into contact with the head gap
sensor.
* For information on operation after printing
is finished, refer to "READJUST TABLE HEIGHT"
(p. 64).
** For information on operation after printing
is canceled, refer to "CANCELED FOR TABLE
HEIGHT" (p. 66) and "CHECK TABLE HEIGHT"
(p. 66).