Setting Print Area For Each Setup Of Media - Roland VersaUV LEF-20 Master Manual

Setting Print Area for Each Setup of Media

Usually, when you make a new setup of media, the print area and base position of the previous setup are set.
You can change them every time you make a new setup of media.
Procedure
1.
Press [MENU] .
2.
Press [ ] to display the figure on the below .
MENU
SUB MENU
3.
Press [ ] twice .
SET AT SETUP
ENABLE DISABLE
4.
Press [ ] or [ ] to select a relevant item .
SET AT SETUP
DISABLE (Default settings)
ENABLE
5.
Press [ENTER] .
6.
Press [MENU] [ ] in this order to return to the original screen .
Explanation
Make a setup using the print area of the previous setup.
The print area of the factory default is the full area (508 x 330 mm).
This setting is suitable when you always perform printing on media of a fixed size.
Set the print area (base position, width, and length of the print area) every time you make
a setup of media.
This setting is suitable when you change the media size according to print.
Making Advanced Setup of Media
Chapter 1 Fully Utilizing the Machine 11