Changing Print Area - Roland VersaUV LEF-20 Master Manual

Making Advanced Setup of Media

Changing Print Area

In the factory default, the base position (home
position) of the print area is at the right front
of the flat table, and the print area is the full
area (508 x 330 mm).
The base position of the print area should be
changed according to the media size.
You can reduce the print time if you narrow
(limit) the print area.
Determining Base Position of Print
Area (Home Position)
Determine the base position used as a base to
set the print area.
1.
Press [MENU] .
2.
Press [ ] to display the figure on the below .
MENU
SUB MENU
3.
Press [ ] .
4.
Press [ ] to display the figure on the below .
SUB MENU
SET BASE POS.
5.
Press [ ] .
SET BASE POS.
LOWER R LOWER R
12 Chapter 1 Fully Utilizing the Machine
6.
Press [ ] or [ ] to select the base position .
SET BASE POS . Print object
Set the base position (home posi-
tion) at the front right of the print
area.
This method is appropriate when
LOWER R
the print site is level, and you can
clearly specify the print area.
"Setting Print Area Using Lower
Right of Media as Base Position" (p.
13)
Set the base position at the center
of the media.
This method is appropriate when
clear specification of the print area
CENTER
is difficult, or when the print site is
curved or uneven.
"Setting Print Area Using Center of
Media as Base Position" (p. 14)
7.
Press [ENTER] .
MEMO
You can select the setting method for the
print area every time you make a setup of
media. For more information "Setting Print
Area for Each Setup of Media" (p. 11).
8.
Press [MENU] [ ] in this order to return to
the original screen .