Roland VersaUV LEF-20 Master Manual page 62

Read This Chapter Whenever You Face a Problem (FAQ)
Problem Items to check
Is the Link LED lit?
The printer unit does
not run
Are the network set-
tings correct?
Did the software RIP
end abnormally?
Is the temperature of
the room too low?
Is something stuck in
the X-axis, Y-axis, or
Z-axis movable axes?
The flat table does not
move
Are any covers open?
Is something covering
The media gap sensor
the media gap sensor
does not sense media
or has it attracted
dust?
60 Chapter 3 Appendix
Action
If the Link LED for the Ethernet connector is not
lit, the network connection has not been made
correctly. Check whether or not the network
routing is appropriate. Try connecting the
computer and the machine to the same hub
or connecting them directly using a crossover
cable. If this makes it possible to perform output,
it means the problem is in the network itself.
Link LED
This lights up green
when the connec-
tion to the network
is correct.
If output is not possible even though the link LED
is on, make sure the IP address and other settings
are correct. The settings on both the machine
and the computer must be appropriate. Redo the
settings, checking to ensure that the IP address
does not conflict with the IP address for another
device on the network, that the port setting for
the software RIP specifies the IP address set on
the machine, that the settings have no typing
errors, and for other such problems.
Make sure the software RIP is running correctly,
then switch the sub power switch off and back
on.
Use the machine in an environment where the
temperature is 20 to 32°C (68 to 90°F)
Check whether or not something is catching or
stuck and interfering with operation.
Close the front cover and panel cover while
starting up or printing. If any cover is open while
starting up or printing, the flat table cannot be
moved for your safety.
Check whether or not something is interfering
with the media gap sensor's ability to sense.
Page
—
"STEP 8: Network Settings"
(First Step Guide)
"Viewing Information
About the System of This
Machine" (p. 26)
"Roland VersaWorks Quick
Start Guide"
—
—
—
—