Roland VersaUV LEF-20 Master Manual page 17

5.
Press [ ] [ ] [
pointer until it points to the center position
of the area you want to print .
6.
Press [ENTER] .
Print heads return to the standby position.
WIDTH: 000.0mm
LENGTH:000.0mm
MEMO
When the media comes into contact with
the head gap sensor, the screen shown
below appears, and the setup is cancelled.
Redo from "2. Setting Height of Media
Automatically" (First Step Guide), or "Setting
Height of Media Manually" (p. 8)
CHECK TABLE
HEIGHT
7.
Press [ ] [ ] to enter the length of the area
you want to print .
8.
Press [ ] [ ] to enter the width of the area
you want to print .
W:508mm L:330mm
H:100.0mm
MEMO
For a test print, set "WIDTH" to 80 mm or
more, and "LENGTH" to 70 mm or more. An
error will occur and test prints cannot be
done if the area is smaller than this.
] [ ] to move the laser
Making Advanced Setup of Media
9.
Close the front cover when it is open .
10.
Press [ENTER] .
The print area is specified. Print heads return
to the standby position.
Make sure the "W (Width), L (Length), and H
(Height)" values on the menu screen are as
intended.
W:508mm L:330mm
H:100.0mm
MEMO
If you want to use the print area specified
here for next printing, switch "SET AT SETUP"
(p. 11) to "DISABLE. " With this setting, you
can make a setup of media without setting
the print area and base position.
Chapter 1 Fully Utilizing the Machine 15