I/O Module Installation Procedures; Table 14 - Connect Input/Output Wiring - Honeywell HC900 User And Installation Manual

I/O Module Installation Procedures

Step
Using Rack #, Slot #,
1
Channel # data from a
Designer Software report,
fill in the tag names on the
Label for each configured
I/O Module. Module slot
position should take heat
de-rating into account.
See Heat Rise De-rating
page 52.
Be sure to use the
appropriate label for each
module type.
Place the appropriate label
2
supplied with the module
(tagname side out) into the
hinged door for each I/O
Module.
Slotted tabs, molded into
the door at top and
bottom, hold the label in
place.
84
Table 14 – Connect Input/Output Wiring
Procedure
HC900 Process & Safety Controller User and Installation Manual
Comments Reference
Revision 6
21 April 2017