Introduction; Purpose - Honeywell HC900 User And Installation Manual

Purpose

This publication describes the installation, operation, and maintenance of the Honeywell HC900 Process Controller.
This publication includes the following sections.
Chapter Title Page

Introduction

Components and
Architecture
Pre-Installation
Planning
Rack Installation
I/O Module
Installation and
Wiring
Communications
Installation
Operating
Characteristics
Redundant
Operating
Characteristics
Diagnostics and
Troubleshooting
Analog Calibration
Removal and
Replacement
Procedures
Specifications
Appendix -
Installation of
Remote
Termination Panels
(RTPs)
Revision 6
21 April 2017
Introduction
1 Model numbers, how to verify component compatibility, function description of
components, feature summary.
17 Functional features and physical characteristics of the system and of each major
component of the HC900 Process Controller. Networking components and
methods of interconnection.
44 Pre-planning considerations and procedural guidelines for planning an installation.
65 Procedures for installing the major components of the system: controller rack, I/O
expansion racks, and communication interconnections.
78 Procedures for installing I/O modules in the controller rack and I/O expansion
racks, and for wiring field devices to the terminal block associated with each
I/O module.
127 Guidelines for installing RS-232, RS-485 to USB cable, RS-485, and Ethernet
cabling and associated components.
155 Characteristics of the HC900 Process Controller as they relate to configuration of
a control strategy, and to operation of an installed and running system.
165 Characteristics of redundant operation.
173 Mechanisms that detect and react to faults in the operation of HC900 Process
Controller hardware and/or software components.
191 Hardware configuration required for calibrating AI and AO modules from the
configuration software.
196 Guidelines for replacing system components; includes Cautions and Warnings as
applicable.
206 Details of HC900 Process Controller design and functioning.
217 The Remote Termination Panel (RTP) provides an easy way to connect the
HC900 controller to the field wiring. The RTP integrates some of the typical
externally connected components, reducing wiring and setup time. It also
minimizes the need for multiple wires under a single screw connection by
expanding the connectivity of the shared terminals of the I/O modules.
HC900 Process & Safety Controller User and Installation Manual
Introduction - Purpose
Content
1