Introduction; Purpose - Honeywell 900U02-0100 User And Installation Manual

1.1.

Purpose

This publication describes the installation, operation, and maintenance of the Honeywell ControlEdge
HC900 Controller. This publication includes the following sections.
Chapter Title

Introduction

Components and
Architecture
Pre-Installation
Planning
Rack Installation
I/O Module
Installation and
Wiring
Communications
Installation
Operating
Characteristics
Redundant
Operating
Characteristics
Diagnostics and
Troubleshooting
Analog Calibration
Removal and
Replacement
Procedures
Specifications
Appendix -
Installation of
Remote
Termination Panels
(RTPs)
Revision 10 ControlEdge HC900 Process & Safety Controller User and Installation Manual
May 2019
1. Introduction
Page
1 Model numbers, how to verify component compatibility, function description of
components, feature summary.
15 Functional features and physical characteristics of the system and of each major
component of the ControlEdge HC900 Controller. Networking components and
methods of interconnection.
40 Pre-planning considerations and procedural guidelines for planning an installation.
69 Procedures for installing the major components of the system: controller rack, I/O
expansion racks, and communication interconnections.
80 Procedures for installing I/O modules in the controller rack and I/O expansion
racks, and for wiring field devices to the terminal block associated with each
I/O module.
137 Guidelines for installing RS-232, RS-485 to USB cable, RS-485, and Ethernet
cabling and associated components.
163 Characteristics of the ControlEdge HC900 Controller as they relate to
configuration of a control strategy, and to operation of an installed and running
system.
173 Characteristics of redundant operation.
179 Mechanisms that detect and react to faults in the operation of ControlEdge HC900
Controller hardware and/or software components.
200 Hardware configuration required for calibrating AI and AO modules from the
configuration software.
204 Guidelines for replacing system components; includes Cautions and Warnings as
applicable.
214 Details of ControlEdge HC900 Controller design and functioning.
221 The Remote Termination Panel (RTP) provides an easy way to connect the
ControlEdge HC900 controller to the field wiring. The RTP integrates some of the
typical externally connected components, reducing wiring and setup time. It also
minimizes the need for multiple wires under a single screw connection by
expanding the connectivity of the shared terminals of the I/O modules.
Introduction - Purpose
Content
1