Table of Contents
Advertisement
M
P
A
ANUAL
ATIO
WNINGS
A
H
TTACHING THE
When replacing the canopy only or replacing the canopy harness, it is necessary to attach the cable to the
inside of the wrap.
For vinyl canopies with Weatherguard, the harness is routed in the seam of the Weatherguard, no
additional attachment is necessary.
For other wraps follow the directions below:
1. Open the awning to access the inside surface of the wrap.
2. Clean the inside surface of the wrap.
3. Attach the harness to the inside surface.
3.1. For Alumaguard: Use 1" by 2" pieces of Velcro (loop) taping
the harness on each slat between the joints.
3.2. For FLXguard: Position the harness approximately 3/8" from
the edge of the material. Attach using a 1" x 6" piece of clear
tape (the tape is a special bond tape available from Carefree).
12
Service Manual
F
ARNESS TO
ABRIC
W
RAP
Carefree of Colorado
1" x 2" Velcro "Loop"
ALUMAGUARD
1" x 6" Clear Tape
Position Wire
3/8" From Edge
FLXguard
052876-301r5
LED008a
Hide quick links:
Advertisement
Table of Contents
