Canopy Replacement - All Models; Removing The Fabric And Roller Tube - Carefree ASCENT Service Manual

A
SCENT
C R
ANOPY EPLACEMENT
Remove and Save
Lower Screws
Spindle Tab
(ref)
Roller Tube & Fabric
Clearly Mark the RH End of Roller Tube
A
DETAIL
Spindle Tab
DETAIL
View of RH Spindle
R F
EMOVING THE
1. Open the room approximately 3"-4".
2. Open the front cover. Refer to page 3.
CAUTION
inserted before continuing otherwise the roller tube can spin out of control and cause personal
injury and/or property damage.
3. (Detail A) On the right end of the roller tube, insert a spring locking pin through the roller bearing and
spindle; it may be necessary to twist the roller to align the holes. The locking pin is a 3/16 x 1 1/4 cotter
pin or equivalent. Place tape over the head of the pin to avoid the pin coming out.
IMPORTANT NOTE: The XL model has two springs. A second spring locking pin must also be
inserted through the LH bearing and spindle and taped in place before continuing.
4. If installed, on the slat assembly remove the lower screws that secure the fabric and slat. It is not necessary to
remove the upper screws. On one end of the slat, swivel the end plate out of the way to clear the lower slot of
the slat.
5. (Detail B) Inside the end caps, remove the spindle tab retaining screws and washers. There is one
screw in each end cap.
4
Service Manual
- A
LL
Slat
Spring Lock Pin
6" Approx.
#10 x 2 Fabric Retaining Screw
Hem on Bottom
Pull Down and Hold Polycord
While Placing Retaining Screw
C
R
ABRIC AND OLLER
The springs are wound and under tension. The spring locking pins must be
M
ODELS
Spindle and Bearing Assy (ref)
#10 x 3/8 Spindle Tab
Retaining Screw
Fabric
T
UBE
Carefree of Colorado
Rotate one End Plate
Down to Expose Fabric Slot
Slide End Cap Out
After Loosening
Screws
Loosen the 2
End Cap Screws
Approximately 1"
#10 Fender Washer
B
DETAIL
Screw Position
#8 x 2 Screw
Gray Polycord
D
DETAIL
052553-301r5
as024