Removing The Right Control Panel - Dell EMC PowerEdge R640 Installation And Service Manual

Figure 107. Installing the left control panel
5 Using Phillips #1 screwdriver, install the screws that secure the cable cover to the system.
Figure 108. Installing the cable cover
Next steps
1 Install the air shroud.
2 If applicable, install the cooling fan #1.
3 Follow the procedure listed in
Related links
Installing the air shroud
Installing a cooling fan

Removing the right control panel

Prerequisites
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. You must route the
cables properly when you replace them to prevent the cables from being pinched or crimped.
3 For ease of removal of the right control panel, remove the cooling fan #8 to access the cable latch.
154 Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
After working inside your system.
Safety instructions.
Before working inside your system.