Removing The Processor From The Processor And Heat Sink Module - Dell EMC PowerEdge R640 Installation And Service Manual

Figure 37. Removing the processor and heat sink module
Next steps
1 Install the PHM module.
Related links
Installing a processor and heat sink module
Removing the processor from the processor and heat sink
module
Prerequisites
WARNING: The heat sink may be hot to touch for some time after the system has been powered down. Allow the heat sink to
cool before removing it.
1 Follow the safety guidelines listed in
2 Follow the procedure listed in
3 Remove the air shroud.
4 Remove the processor and heat sink module.
Steps
1 Place the heat sink with the processor side facing up.
2 Insert a flat blade screwdriver into the release slot marked with a yellow label. Twist (do not pry) the screwdriver to break the thermal
paste seal.
3 Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
Safety instructions.
Before working inside your system.
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
89