Dell EMC PowerEdge R640 Installation And Service Manual page 149

Figure 103. Installing the system board
Next steps
1 Install the Trusted Platform Module (TPM).
NOTE: The TPM plug-in module is attached to the system board and cannot be removed. A replacement TPM plug-in
module is provided for all system board replacements, where a TPM plug-in module was installed.
2 Replace the following:
a Integrated storage controller card
b Internal USB key (if applicable)
c USB 3.0 module (if applicable)
d IDSDM/vFlash module card
e All expansion card risers
f Processors and heat sink modules
g Processors and memory blanks (if applicable)
h Memory modules and memory module blanks
i Network daughter card
j Air shroud
k Power supply unit(s)
3 Reconnect all cables to the system board.
NOTE: Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
4 Follow the procedure listed in
5 Ensure that you:
a Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see the
Restoring the Service Tag by using the Easy Restore feature section.
c Update the BIOS and iDRAC versions.
d Re-enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module section.
After working inside your system.
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
149