Installing The Network Daughter Card - Dell EMC PowerEdge R640 Installation And Service Manual

Steps
1 Using a Phillips #2 screwdriver, loosen the captive screws that secure the network daughter card (NDC) to the system board.
2 Hold the NDC by the edges on either side of the touch points, and lift to remove it from the connector on the system board.
3 Slide the NDC towards the front of the system until the Ethernet connectors are clear of the slot in the back panel.
Figure 65. Removing the network daughter card
Next steps
Install the NDC.
Related links
Removing an expansion card riser

Installing the network daughter card

Installing the network daughter card
Prerequisites
Follow the safety guidelines listed in
Steps
1 Orient the NDC so that the Ethernet connectors fit through the slot in the chassis.
2 Align the captive screws at the back-end of the card with the screw holes on the system board.
3 Press the touch points on the card until the card connector is firmly seated on the system board connector.
4 Using a Phillips #2 screwdriver, tighten the captive screws to secure the NDC to the system board.
Safety instructions.
Dell EMC PowerEdge R640 Installation and Service Manual
Installing and removing system components
115