ABB Aztec 600 User Manual page 33

Aztec 600 aluminium, ammonia, color, iron, manganese, phosphate
Single- and multi-stream colorimetric analyzers
Fields
Operator level security
Operator level password
The following fields are displayed only if 'Security system' is set to 'Advanced'.
Reconfigure preset
Password expiry
Inactive user disabling
Password failure limit
Min password length
30
Description
Sets access to the 'Calibration & Maintenance' and 'Logging' menus.
If set to 'Off', no password is required.
If set to 'On' and 'Security type' is set to 'Basic' an additional 'Operator level password' field is
displayed.
If set to 'On' and 'Security type' is set to 'Advanced', all users are required to enter their user
password to gain access to the 'Calibration & Maintenance' and 'Logging' menus.
Displayed only if 'Security system' is set to 'Basic' and 'Operator level security' is set to 'On'. All
users are required to enter this password to gain access to the 'Calibration & Maintenance' and
'Logging' menus.
Passwords are set initially by User 1 (System Administrator) but any user can make subsequent
changes to their own password.
When set to 'Yes' each user must change their password after it is used for the first time following
initial configuration.
Select the number of days that the password is valid for. When a password expires, the user is
prompted to provide a new password.
Select the number of days after which an inactive user's access privileges are de-activated.
Enter the number of consecutive incorrect password entries allowed by a user. If the number of
incorrect entries exceeds this limit, the user's access privileges are de-activated and can be
reinstated only by the System Administrator (User 1).
Sets the minimum length required for user's passwords.
6 Configuration
IM/AZT6CR–EN Rev. J