Preparing For Rides At High Temperature And Slow Speed; Preparing For Rides At Low Temperature Or In Snow - Husqvarna TX 125 Owner's Manual

8 PREPARING FOR USE
8.8

Preparing for rides at high temperature and slow speed

8.9

Preparing for rides at low temperature or in snow

–
Fit the steel sprocket.
–
Clean the motorcycle. (
–
Straighten bent radiator fins carefully.
600868-01
–
Check the radiator cap.
Value on radiator cap
» If the displayed value does not equal the setpoint value:
M01129-01
–
Change the radiator cap.
–
Adjust the secondary drive to the road conditions.
Info
The transmission oil heats up quickly when the clutch is operated fre-
quently due to an excessively high secondary drive.
–
Clean the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
600868-01 –
Check the coolant level. (
–
Fit a waterproofing device on the air filter.
Waterproofing device for air filter (79006921000)
Info
Observe the fitting instructions for Husqvarna Motorcycles accessories.
–
Adjust the carburetor jetting and setting.
Info
102137-01
The recommended carburetor tuning is available from your authorized
Husqvarna Motorcycles workshop.
p. 111)
Warning
Danger of scalding During motorcycle operation, the coolant
gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling
system components if the engine or the cooling system are at
operating temperature.
–
Allow the cooling system and the engine to cool down before
you open the radiator, the radiator hoses or other components
of the cooling system.
–
In the event of scalding, rinse the area affected immediately
with lukewarm water.
p. 96)
1.8 bar (26 psi)
29