Preparing For Rides On Dry Sand - Husqvarna TX 125 Owner's Manual

8 PREPARING FOR USE
–
Check the electrical connector for humidity and corrosion and to ensure it is firmly seated.
» If humidity, corrosion, or damage is found:
–
Clean and dry the connector, or change it if necessary.
Difficult riding conditions are:
–
Rides on dry sand. (
–
Rides on wet sand. (
–
Rides on wet and muddy surfaces. (
–
Rides at high temperature and slow speed. (
–
Rides at low temperature or in snow. (
8.5

Preparing for rides on dry sand

p. 27)
p. 28)
p. 28)
p. 29)
p. 29)
–
Check the radiator cap.
Value on radiator cap
» If the indicated value does not correspond to the required value:
M01129-01
–
–
Fit a dust cover on the air filter.
Dust cover for air filter (79006920000)
Info
Observe the fitting instructions for Husqvarna Motorcycles accessories.
102136-01
–
Fit a sand cover on the air filter.
Sand cover for air filter (79006922000)
Info
Observe the fitting instructions for Husqvarna Motorcycles accessories.
–
Adjust the carburetor jetting and setting.
Info
102138-01
The recommended carburetor tuning is available from your authorized
Husqvarna Motorcycles workshop.
–
Clean the chain.
–
Fit the steel sprocket.
Tip
Do not grease the chain.
–
Clean the radiator fins.
–
Straighten bent radiator fins carefully.
Condition
600868-01
Regular use in sand
Warning
Danger of scalding During motorcycle operation, the coolant
gets very hot and is under pressure.
–
Do not open the radiator, the radiator hoses or other cooling
system components if the engine or the cooling system are at
operating temperature.
–
Allow the cooling system and the engine to cool down before
you open the radiator, the radiator hoses or other components
of the cooling system.
–
In the event of scalding, rinse the area affected immediately
with lukewarm water.
Change the radiator cap.
1.8 bar (26 psi)
27