Installing The Shock Absorber - Husqvarna TX 125 Owner's Manual

12 SERVICE WORK ON THE CHASSIS
12.17

Installing the shock absorber

–
Remove the connecting link of the chain.
–
Take off the chain.
F00294-01
–
Remove nut
–
Push the swingarm back and secure it against falling over.
V00397-10
–
Hold the shock absorber and remove screw
–
Remove the shock absorber carefully at the bottom.
V00398-10
Main work
–
Carefully position the shock absorber into the vehicle from the bottom.
–
Mount and tighten screw
Guideline
Screw, top shock
absorber
V00399-10
–
Position the swingarm and mount the swingarm pivot.
Info
Pay attention to flat area
–
Mount and tighten nut
Guideline
Nut, swingarm pivot
V00400-10
–
Mount the chain.
–
Connect the chain with connecting link
Guideline
The closed side of the chain joint lock must face in the direction of travel.
F00294-11

and pull out the swingarm pivot.

.
M10

.
 .

.
Loctite
60 Nm
(44.3 lbf ft)
M16x1.5 100 Nm
(73.8 lbf ft)

.
53
® 2701™