When not Controlling the Exposure Time
Configure the settings as follows.
Exposure Mode
The exposure will be performed with an exposure time equal to 1 / frame rate.
Note
• [Exposure Time] will be disabled.
• [Exposure Auto] cannot be used.
Step 5: Adjusting the Image Quality
Adjust the image quality using the gain and white balance (GO-2400C-USB only) functions.
To adjust the image quality
The display level must be changed from [Beginner] to [Guru].
Adjusting the Gain
Adjust the sensitivity via the analog gain (i.e., master gain).
For details on gain control, see "Gain Control" (page 29) in the "Main Functions" section.
■ Manual adjustment
1
Expand [Analog Control], and set [Gain Auto] to [Off].
([Off] is the default setting.)
2
Configure the gain.
u Expand [Analog Control], and select the gain you want to configure in [Gain Selector].
• For the GO-2400M-USB, only [Analog All] (master gain) can be configured.
• For the GO-2400C-USB, [Analog All] (master gain), [Digital Red] (digital R gain), and [Digital
Blue] (digital B gain) can be configured individually.
v Configure the gain value in [Gain].
• [Analog All] (master gain) can be set to a value from x1 to x16 (0 dB to +24 dB). The
resolution is set in x0.01 steps (0.005 dB to 0.08 dB depending on the setting value). Values
are configured by multipliers.
• For the GO-2400C-USB, the [Digital Red] (digital R gain) and [Digital Blue] (digital B gain)
can be set to a value from x0.45 to x5.62 (–7 dB to +15 dB) the [Analog All] (master gain)
value. The resolution is set in x0.01 steps.
Item
— 19 —
GO-2400M-USB / GO-2400C-USB
Setting value / selectable range
Off