Configure Your Machine For A Wireless Network Using The One Push Method Of Wi-Fi Protected Setup ™ (Wps) - Brother HL-L8260CDN Online User's Manual

Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless
Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected
™
Setup (WPS)
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup
Related Models: HL-L8260CDW/HL-L8360CDW/HL-L9310CDW
If your wireless access point/router supports WPS (PBC: Push Button Configuration), you can use WPS from
your machine's control panel menu to configure your wireless network settings.
Routers or access points that support WPS are marked with this symbol:
>> HL-L8260CDW
>> HL-L8360CDW/HL-L9310CDW
HL-L8260CDW
1. Press a or b to select the [Network] option, and then press OK.
2. Press a or b to select the [WLAN] option, and then press OK.
3. Press a or b to select the [WPS] option, and then press OK.
4. When [WLAN Enable?] appears, press a to select On.
This will start the wireless setup wizard. To cancel, press Cancel.
5. When the LCD displays [Press Key on rtr], press the WPS button on your wireless access point/router.
Then press a on your machine. Your machine will automatically detect your wireless access point/router and
try to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, insert the Brother installation disc into your computer or go to your model's Downloads page on the
Brother Solutions Center at support.brother.com.
HL-L8360CDW/HL-L9310CDW
1. Press [Settings] > [All Settings] > [Network] > [WLAN] > [WPS].
2. When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. When the Touchscreen displays [Start WPS on your wireless access point/router, then
press [OK].], press the WPS button on your wireless access point/router. Then press [OK] on your
machine. Your machine will automatically detect your wireless access point/router and try to connect to your
wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
™
(WPS)
81