Clean The Drum Unit - Brother HL-L8260CDN Online User's Manual

Home > Routine Maintenance

Clean the Drum Unit

If your printout has black or white dots or other repeating marks at 94 mm intervals, the drum may have foreign
material, such as glue from a label, stuck on the drum surface.
>> HL-L8260CDN/HL-L8260CDW
>> HL-L8360CDW/HL-L9310CDW
HL-L8260CDN/HL-L8260CDW
1. Make sure the machine is in Ready Mode.
2. Press a or b to select the following:
a. Select [Print Reports]. Press OK.
b. Select [Drum Dot Print]. Press OK.
The machine prints the Drum Dot Check Sheet.
3. Press and hold
4. Press the front cover release button and pull open the front cover.
5. Hold the drum unit's green handle. Pull the drum unit out of the machine until it stops.
6. Turn the green lock lever (1) counterclockwise until it locks in the release position. Holding the green handles
of the drum unit, lift the front of the drum unit and remove it from the machine.
1
IMPORTANT
Hold the green handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit.
> Clean the Machine
to turn the machine off.
> Clean the Drum Unit
331