Configure Your Machine For A Wireless Network Using The One Push Method Of Wi-Fi Protected Setup ™ (Wps) - Brother DCP-J572DW Online User's Manual

Home > Network > Additional Methods of Configuring Your Brother Machine for a Wireless
Network > Configure Your Machine for a Wireless Network Using the One Push Method of Wi-Fi Protected
™
Setup (WPS)
Configure Your Machine for a Wireless Network Using the One Push
Method of Wi-Fi Protected Setup
If your wireless access point/router supports WPS (Push Button Configuration), you can use WPS from your
machine's control panel menu to configure your wireless network settings.
Routers or access points that support WPS are marked with this symbol:
>> DCP-J572DW/MFC-J491DW
>> DCP-J772DW/MFC-J690DW/MFC-J890DW
DCP-J572DW/MFC-J491DW
1. Press Settings.
2. Press a or b to select the following:
a. Select [Network]. Press OK.
b. Select [WLAN]. Press OK.
c. Select [WPS]. Press OK.
3. When [Enable WLAN?] appears, press c.
The wireless setup wizard starts. To cancel, press d.
4. When the LCD instructs you to start WPS, press the WPS button on your wireless access point/router. Then
press c on your machine. Your machine automatically tries to connect to your wireless network.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for
operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads
page on the Brother Solutions Center at support.brother.com.
DCP-J772DW/MFC-J690DW/MFC-J890DW
1. Press [Settings] > [All Settings] > [Network] > [WLAN] > [WPS].
2. When [Enable WLAN?] appears, press [Yes].
The wireless setup wizard starts. To cancel, press [No].
3. When the touchscreen instructs you to start WPS, press the WPS button on your wireless access point/
router. Then press [OK] on your machine. Your machine automatically tries to connect to your wireless
network.
If your wireless device is connected successfully, the LCD displays [Connected].
You have completed the wireless network setup. To install the Full Driver & Software Package necessary for
operating your machine, insert the Brother installation disc into your computer, or go to your model's Downloads
page on the Brother Solutions Center at support.brother.com.
™
(WPS)
348