Brother HL-L8260CDN Online User's Manual page 90

Click (Start) > Devices and Printers > Add a device.
®
• Windows 8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
®
• Windows 10
Click > Windows System > Control Panel. In the Hardware and Sound group, click Add a device.
• To use a Windows
your network in advance. For more information, see the instructions supplied with your wireless LAN
access point/router.
• If you use Windows
after the wireless configuration by following the on-screen instructions. To install the full driver and
software package, use the Brother installation disc.
9. Select your machine and click Next.
10. Type the PIN displayed on the machine's LCD, and then click Next.
®
11. (Windows 7) Select your network, and then click Next.
12. Click Close.
If your wireless device is connected successfully, the machine's LCD displays [Connected].
You have completed the wireless network setup. To install drivers and software necessary for operating your
device, insert the Brother installation disc into your computer or go to your model's Downloads page on the
Brother Solutions Center at support.brother.com.
HL-L8360CDW/HL-L9310CDW
1. Press [Settings] > [All Settings] > [Network] > [WLAN] > [WPS w/ PIN Code].
2. When [Enable WLAN?] appears, press [Yes].
This will start the wireless setup wizard. To cancel, press [No].
3. The LCD displays an eight-digit PIN and the machine starts searching for a wireless LAN access point/router.
4. Using a computer connected to the network, in your browser's address bar, type the IP address of the device
you are using as the Registrar. (For example: http://192.168.1.2)
5. Go to the WPS settings page and type the PIN, and then follow the on-screen instructions.
• The Registrar is usually the wireless LAN access point/router.
• The settings page will differ depending on the brand of wireless LAN access point/router. For more
information, see the instructions supplied with your wireless LAN access point/router.
If you are using a Windows
following steps:
6. Do one of the following:
®
• Windows 7
Click (Start) > Devices and Printers > Add a device.
®
• Windows 8
Move your mouse to the lower right corner of your desktop. When the menu bar appears, click Settings >
Control Panel > Hardware and Sound > Devices and Printers > Add a device.
®
• Windows 10
Click > Windows System > Control Panel. In the Hardware and Sound group, click Add a device.
® ®
7, Windows 8, or Windows
® ®
7, Windows 8, or Windows
® ®
7, Windows 8, or Windows
®
10 computer as a Registrar, you must register it to
®
10 as a Registrar, you can install the printer driver
®
10 computer as a Registrar, complete the
85