Brother HL-L8260CDN Online User's Manual page 369

Level 2 Level 3
Wired LAN TCP/IP
Ethernet
Wired Status
MAC Address
Set to Default -
Wired Enable
WLAN TCP/IP
Setup Wizard
WLAN Assistant -
WPS
WPS w/ PIN
Code
WLAN Status
Level 4 Level 5
WINS Server Secondary Specify the IP address of the secondary WINS
DNS Server Primary
Secondary Specify the secondary DNS server's IP address.
IP Boot -
Tries
APIPA -
IPv6 -
- -
- -
- -
-
- -
Boot Method -
IP Address -
Subnet Mask -
Gateway -
Node Name -
WINS Config -
WINS Server Primary
Secondary Specify the IP address of the secondary WINS
DNS Server Primary
Secondary Specify the secondary DNS server's IP address.
IP Boot -
Tries
APIPA -
IPv6 -
- -
-
- -
- -
Status -
Signal -
Description
server.
Specify the primary DNS server's IP address.
Specify the number of attempts the machine will
try to obtain an IP address when the Boot
Method is set to any setting except Static.
Allocate the IP address from the link-local
address range automatically.
1
Enable or disable the IPv6 protocol.
Choose the Ethernet link mode.
Display the Ethernet link status.
Display the MAC address of the machine.
Restore wired network settings of your machine
to the factory settings.
Turn the wired interface on or off.
Choose the IP method that best suits your
needs.
Enter the IP address.
Enter the Subnet mask.
Enter the Gateway address.
Enter the Node name.
Select the WINS configuration mode.
Specify the IP address of the primary WINS
server.
server.
Specify the primary DNS server's IP address.
Specify the number of attempts the machine will
try to obtain an IP address when the Boot
Method is set to any setting except Static.
Allocate the IP address from the link-local
address range automatically.
1
Enable or disable the IPv6 protocol.
Configure the wireless network settings using
the setup wizard.
Configure your wireless network settings using
the Brother installation disc.
Configure your wireless network settings using
the one-button push method.
Configure the wireless network settings using
WPS with a PIN code.
Display the wireless Ethernet link status.
Display the signal condition.
364