Brother HL-L8260CDN Online User's Manual page 263

Error Message
Registration
Replace Belt
Replace Drum
Replace Toner
Replace WT Box
Self-Diagnostic
Short paper
Size Error
Size Error DX
Size Mismatch
Toner Error
Cause
Registration failed.
It is time to replace the belt unit.
It is time to replace the drum unit.
The drum unit counter was not
reset when a new drum was
installed.
The toner cartridge is at the end of
its life. The machine stops all print
operations.
It is time to replace the waste
toner box.
The temperature of the fuser unit
does not rise to a specified
temperature within the specified
time.
The fuser unit is too hot.
The length of the paper in the tray
is too short for the machine to
deliver it to the Face down output
tray.
The paper size defined in the
printer driver is not supported by
the defined tray.
The paper size specified in the
machine's paper size setting is not
available for automatic 2-sided
printing.
The paper in the tray is not the
correct size and is not available
for automatic 2-sided printing.
The paper in the tray is not the
correct size.
One or more toner cartridges are
not installed or not installed
correctly.
Action
• Press Go to retry the colour registration.
• If the error continues, press and hold down
to turn the machine off.
Wait a few seconds, and then turn on the
machine again.
Perform the colour registration using the
control panel.
• Install a new belt unit.
• If the problem continues, contact Brother
customer service or your local Brother
dealer.
Replace the belt unit with a new one.
Replace the drum unit with a new one.
See Related Information: Replace the Drum
Unit.
Reset the drum unit counter.
See the instructions included with the new
drum unit.
Replace the toner cartridge for the colour
indicated on the LCD.
Replace the waste toner box with a new one.
Press and hold to turn the machine off,
wait a few seconds, and then turn it on again.
Leave the machine idle for 15 minutes with the
power on.
Open the back cover (Face up output tray) to
let the printed page exit onto the Face up
output tray. Remove the printed pages, and
then press Go.
Choose a paper size supported by the defined
tray.
Press Cancel (if required).
Load the correct size of paper in the tray and
set the tray for that paper size.
Choose a paper size supported by 2-sided
printing.
Paper size available for automatic 2-sided
printing is A4.
Load the correct size of paper in the tray
indicated on the LCD and set the size of paper
for the tray. Press Go.
Pull out the drum unit. Remove all the toner
cartridges, and then put them back into the
drum unit.
258