Switch (Switches) Page - Kurzweil FORTE SE Musician's Manual

A setting of None means no message is sent when exiting the Multi.

SWITCH (Switches) Page

Press the Switch soft button to view pages where you can set parameters for each of the Forte
SE switch controllers.
You can select any of the Forte SE's switch controllers by moving the cursor to the "Switch"
parameter, and using either the Alpha Wheel or Value buttons to scroll through the list.
Alternatively, you can also position the cursor in the "Switch" parameter, hold down the
Enter button and press the Switch you wish to edit.
Switch
The Switch parameter allows you to assign any of the Forte SE's physical Switches (assignable
switches, switch pedals and certain buttons) to control a program specific parameter or MIDI
controller number for the currently selected zone.
First, use the Channel/Layer/Zone buttons to the right of the display to select the desired
Zone that you wish to assign a switch for. Next, on the Multi Switches page, use the
navigation buttons to select the "Switch" field, hold the Enter button and then push the
Forte SE switch you want to assign. This will select that switch and display its available
parameters. (You can also scroll through the list of switches by using the Alpha Wheel or the
Value buttons to scroll through the list).
If a pedal is selected which has a pedal override enabled in Global mode, a message "(Global
Override)" will display when that pedal is viewed to remind you that the Global mode pedal
override settings are being used instead of the Multi mode pedal settings.
Parameter
Switch
Type
Mode
Dest (Destnation)
OnValue
OffValue
Entry State
Exit State
Range Of Values
See Switch Controllers List
Momentary, Toggled
Off, MIDI CC, Chord
See Multi Destination Control List
None, 0 to 127
None, 0 to 127
None, Off, On
None, Off, On
Multi Edit Mode
SWITCH (Switches) Page
11-17