Controlling Program Parameter Assignments From Multi Mode; The Controller Destination List - Kurzweil FORTE SE Musician's Manual

Multi Edit Mode

Controlling Program Parameter Assignments from Multi Mode

Off Value
The Off Value is the MIDI value sent when a switch controller is set to Off. You can set this
parameter to any number between 0 and 127, or to None.
Entry State
The Entry State parameter determines the state of the Foot Switch or button that is sent as a
MIDI message when the current Multi is loaded. You can set this parameter to None, On, or
Off. This parameter is common to all Zones.
None can be entered with the alphanumeric function of the Category buttons as -1.
If Sound Select is set to None, then when you load the current Multi, no value will be
transmitted. If you specify an Entry State, then a MIDI controller message with this value
will be sent when you load the current Multi.
Exit State
The Exit State parameter determines the state of the Foot Switch or button that is sent as a
MIDI message when the current Multi is exited. You can set this parameter to None, On, or
Off. This parameter is common to all Zones.
None is entered with the alphanumeric function of the Sound Select buttons as -1.
If Exit State is set to None, then when you leave the current Multi by selecting another Multi
or Program, the Foot Switch or button will remain at whatever value corresponds to its
current position. If you specify an Exit State, then a MIDI controller message with this value
will be sent when you select a different Multi or Program.
Controlling Program Parameter Assignments from
Multi Mode
Commonly you will want to assign a physical controller in a Multi to control the same
Program parameter that it controlled in Program Mode. In the Destination (Dest) field on
the Multi Switches or Multi CCs page, destinations that are assigned to parameters for the
Program of the current Zone will show the Program Parameter name in place of the standard
Controller Destination name. Select one of these destinations to control an assigned Program
parameter.

The Controller Destination List

The table below contains the available values for the MIDI CC (continuous controller)
destinations. The Forte SE's physical controllers can send MIDI values to these destinations
in order to control the parameters of Forte SE Programs, Multis, Forte SE system parameters,
or external MIDI equipment.
11-20