The Dsp Control (Dspctl) Page - Kurzweil FORTE SE Musician's Manual

Program Edit Mode

The DSP Control (DSPCTL) Page

In addition to having a selectable function, each function block has three editable
parameters: number of inputs, number of outputs, and block size (the Output Mode
parameter is an editable parameter of the algorithm as a whole). When you first enter
the EditAlg page, there will be a cursor in the parameter field, and the first block of the
algorithm will be highlighted. To select a block for editing, move the cursor down the display
until no parameter field is highlighted; then, using the < and > buttons, highlight the block
you wish to edit. Press the ^ button to move the cursor back into the parameter fields, and
then select the parameter you wish to edit.
The Output Mode parameter determines the number of outputs from the algorithm. With
Output Mode set to Normal, the algorithm has one output. With Output Mode set to Sep.
L/R, the algorithm has two outputs, each of which is sent to a separate stereo channel.
To edit the signal path, select either an input of a block or an output of the entire algorithm.
By scrolling with Alpha Wheel or the Previous- and Next+ buttons, you can see every
possible configuration for that selected signal path.
The DSP Control (DSPCTL) Page
Before reading further, be sure to read
Control Parameters on page
Press the DSPCTL soft button to call up the DSP Control (DSPCTL) page, which is
displayed below:
7-38
7-33.
Function Parameter
Pitch
Fine Adjust
Hertz Adjust
Pitch
Key Tracking
Velocity Tracking
(Function 1-4) (Function-Parameter)
Level
Key Tracking
Level
Velocity Tracking
Algorithm Basics on page 7-32
Range of Values
-128 to 127 semitones
± 100 cents
± 10.00 Hertz
± 2400 cents/key
± 7200 cents
(Depends on Function)
-96 to 24 decibels
± 2.00 decibels/key
± 96 decibels
and Common DSP
Default
0
0
0
0
0
(Depends on Function)
-6
0
35