Table of Contents
Advertisement
Label
IR/TV video swap
Default settings
8.2.4.6
System info
10056203;a1
Figure 8.10 System information dialog box
The System information dialog box contains information about the system, such as:
Label
Video mode
Runtime
System check ID
Hardware and firmware information is also available.
Publ. No. 1 557 544 Rev. a121 – ENGLISH (EN) – October 6, 2005
Explanation
Yes or No
If Yes is selected the active video signal is
swapped between the two video outputs on the
pan/tilt head when the operator toggles between
IR and TV.
If two monitors are used (one for IR and one for
TV) this means that the images move between the
monitors, instead of only moving the indicator for
active channel between the monitors.
SEE: See section 7.2.2.7 – Active channel indicator
on page 13.
Yes or No
NOTE: Selecting Yes resets all parameters to
factory settings.
Explanation
NTSC or PAL
Hours and minutes
Configuration number
8.2 – On-screen menus
27
Advertisement
Table of Contents
