Table of Contents
Advertisement
5
Mechanical installation
Different applications call for different ways of mechanically installing the imager unit
and therefore specific information regarding the installation can not be given. However,
the imager unit has a mounting plate (with one 3/8"-16 UNC and two 1/4"-20 UNC
threaded holes) on the bottom side of the housing designed to match an existing
platform.
Mounting plates with a different hole layout can be made by custom order at FLIR
Systems AB Imaging Sweden.
SEE ALSO: For more information about mounting plates, see section 12.13 – Basic dimensions – Imager;
view from below on page 47.
9
Publ. No. 1 557 544 Rev. a121 – ENGLISH (EN) – October 6, 2005
Advertisement
Table of Contents
