Table of Contents
Advertisement
8.2 – On-screen menus
Label
Protocol
Change password
26
Explanation
5X0
■
TASS
■
PELCO D (NOTE: By default, a ThermoVision™
■
Sentinel system is shipped without PELCO D
protocol. The customer must specifically re-
quest PELCO D protocol.)
Protocol is selectable to 5X0, TASS or PELCO D.
The 5X0 protocol is also used in the ThermaCAM™
500 series cameras and is an ASCII protocol using
'xon/xoff handshaking'. If the protocol is changed,
it will be necessary to restart the system before the
change will take effect.
Optional protocols are available upon request.
NOTE: The 5X0 protocol is a point-to-point
protocol. No Device ID can be selected.
NOTE: When using the Remote Control (RC), 5X0
protocol is required.
Yes or No
When the maintenance menu is entered, a pass-
word dialog box will appear (if the password is the
default system value 0000, the password dialog
box will not be displayed).
To change a value, use the up/down arrow buttons.
To select another digit, use the left/right arrow
buttons. When the right password is present, press
the ENTER button. If the wrong password is en-
tered a warning will appear. When the correct
password is entered the maintenance menu will
appear.
To change the password, set the Change pass-
word selection to Yes, and press the ENTER but-
ton. A dialog box will appear allowing the operator
to enter the new password.
Publ. No. 1 557 544 Rev. a121 – ENGLISH (EN) – October 6, 2005
Advertisement
Table of Contents
