Table of Contents
Advertisement
4. Installation
4.4
Positioning the appliance
200
4.5
Levelling
1
4.6
Installing the temperature sensors
2
1
22
1. Remove the packaging from the DHW calorifier, leaving the
calorifier on the pallet used for transport.
2. Remove the protective packaging.
3. Remove the 3 screws securing the calorifier to the pallet.
4. Lift the DHW calorifier and place it in its final position, respecting
the distances shown on the diagram.
200
M003153-A
The DHW calorifier is levelled using the 3 feet (delivered in the
instructions pack) to be screwed to the bottom of the DHW calorifier.
1. Mount the 3 adjustable feet under the appliance.
2. Level the appliance using the adjustable feet.
2
L000382-A
¼See sensor location: "Main dimensions", page 21
1. Insert the sensor into the sensor tube with the help of the sensor
tube separator.
The sensor tube separator is provided in the instructions bag.
2. Check that the sensors are correctly positioned in the sensor
3
tube.
3. Check the mounting of the sensor tube separator.
CAUTION
Have 2 people available.
4
Handle the appliance with gloves.
4
Adjustment range: 10 mm.
4
Use metal blocks under the feet of the calorifier if
4
necessary.
CAUTION
Do not place the blocks on the exterior sides of the
domestic hot water calorifier.
The sensors are preinstalled if the calorifier is pre-fitted
with a solar technical station.
200SE-2S - 300SE-2S
26/04/2016 - 7607575-05
Advertisement
Table of Contents
