Registering Or Deletion]; Problem; Cause; Solution - IDTECK 100R Manual

2

[Registering or Deletion]

2.1

Problem

User Card or PIN cannot be registered additionally.

Cause

An error in using a product or in system settings
●
Over permissible register person
●

Solution

Make sure that installation and operation are normal.
☞ When installing the 100R first or When finishing system initialization#1).
Because system is the status of initialization, register mode selection, master card (or PIN) an
d user.
1. 100R Mode Selection: Mode Number + ENT
RF Only 01 + ENT
RF + P/W 02 + ENT
PIN Only 03 + ENT
RF or PIN 05 + ENT
2. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
3. By modes, enter the master card, PIN and password.
4. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
See "Initial Setting" to register master or user.
☞ When registering a user card additionally while using a product.
Register a user card only because master card is registered.
1. Enter the master card (or PIN: 4 to 6digit (mode 03 or 05) + ENT).
2. By modes, enter "Mode Number + ENT" to add user access cards.
RF Only 11 + ENT
RF + P/W 12 + ENT
PIN Only 13 + ENT
[Registering or Deletion] p.53