Provisioning The Lrm; Alarms And Events - Symmetricom SSU-2000 User Manual

Provisioning the LRM

The following information provides examples of how to use ICS and TL1 commands
to provision an LRM in an SSU-2000. Refer to
266, and Interactive Command
commands.
Examples
The following ICS commands enable port 2 on an LRM in slot 8 of shelf 3, set the
line build-out to 399 feet, and set the slip error threshold to 6:
LRM 3A8-2 ENABLE
LRM 3A8-2 LBO 399
LRM 3A8-2 SLIP 6
SET-PRMTR-LRM::S3A8-2:::ON,399,6,,;
The following ICS commands enable port 3 of an LRM in slot 11 of shelf 2 and
enables a FAULT strategy,:
LRM 2A11-3 FLT AIS
SET-PRMTR-LRM::S2A11-3:::ON,,,,,AIS;
The following ICS commands set the circuit ID of port 4 on an LRM in slot 7 of shelf
1 to 1A7-4:
LRM 1A7-4 CID 1A7-4
SET-PRMTR-LRMCID::S1A7-4:::1A7-4;

Alarms and Events

The LRM generates the alarms and events listed in
respectively.
12713020-002-2 Revision D – April 2004
Set, on page 315, for details on ICS and TL1
then press Enter
then press Enter
then press Enter
then press Enter
then press Enter
Output Module Reference Data
Line Retiming Unit (LRU)
TL1 Command Interface, on page
Table A-4 and Table
SSU-2000 User's Guide 217
A-9,