Status Led Indicators; E1 Input Module Event Reporting - Symmetricom SSU-2000 User Manual

Input Module Reference Data
1-Port and 3-Port E1 Input Modules
E1 Input Module Events Reported
The E1 Input module reports the event types listed in
Table 7-2. E1 Input Module Event Reporting
Event
Module installed
Module enabled
Module disabled
Module restarted
Input Signal Episode,
Alarm, and Faults
Hardware Faults
Received SSM Changed
Phase Buildout
Configuration Changes
Input phase zeroed

Status LED Indicators

The E1 Input module is equipped with a set of status LED indicators that indicate
module and incoming signal status. These LEDs are shown in
model illustrated) and described in
150 SSU-2000 User's Guide
Parameter One
–
–
–
Delay before restart (in s)
–
–
New PQL
Phase value being built out
New Value (if necessary)
–
Table
Table 7-2
Parameter Two
–
–
–
–
–
–
Old PQL
Corrected phase value
Old Value (if not implied by new value)
–
Figure 7-2
7-3.
12713020-002-2 Revision D – April 2004
when they occur:
(3-port