To Rem Ove And Attach The Foot Holder; Seam Guide; Changing The Needle - ELNA 3003 Instruction Manual

TO REMOVE AND ATTACH THE FOOT HOLDER SEWING IN REVERSE SEAM GUIDE
To remove:
To attach: As long as you keep the reverse stitch push The numbers on the needle plate indicate the
button depressed, the machine sews back- space between the line and the left needle
Unscrew counterclockwise using a screw Align the hole in the foot holder with the wards position.
driver,
threaded hole in the presser bar and fit the The numbers at the front are in millimeters.
foot holder screw into the hole.
The numbers at the back are in ,nches.
Tighten the screw by turning it clockwise
CHANGING THE NEEDLE
Raise the needle by turning the balance Loosen the needle clamping screw by turning
wheel towards you or by pressing the up/ it counter-clockwise.
down needle position key (model 30071
L I
Lower the presser foot
Remove the needle from the clamp.
Insert the new needle into the clamp with the
flat side to the rear, pushing it up as far as it
will go.
Tighten the clamping screw firmly, with the
screwdriver, if needed.
*Check
the needle regularly for barbed or
blunted
point. A defeclive needle may spoil
your fabrics.